SunFounder Raspberry Pi RAB Holder Breadboard Kit with 830 Points solderless Circuit Board Raspberry Pi Holder for Arduino Uno R3, Mega 2560 & Raspberry Pi 3B+, 3 Model B, 2 Model B and 1 Model B+

The Extension Board is perfectly crafted for continuous and heavy usage. Connect more than 5 devices at a time. Made of top quality material to perform long. If you use lots of electronic devices then one wall socket is not enough for you, you need an extension board. If your charger wire is not long enough and you want to use the device at some place far then you can have an extension board.

There are two types of extension board one in which The cord can be wound into the extension itself. and the other one is in which the cord cannot be wounded into the extension. You can purchase any one of them as per your need.

Buy Now


Product Description:

This RAB Holder Kit provides you all the necessary components for a simple experiment, including threads for easy screwing, slots for plugging wires, an RAB holder, nine LEDs, and ten 1K current-limiting resistors, thus you can start the experiment right away.
With this kit, you can fix your Arduino board, Raspberry Pi, and breadboard on the RAB Holder, free of careless short circuits on a metal desk or caused by some metal parts underneath. What’s more, it also comes with 65pcs jumper wires with different length in various colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.

Size: 200 x 135 mm (7.87 x 5.31 inch)

Package Included
1 x RAB Holder
1 x 830-Point Breadboard
65 x Jumper Wire
1 x 20cm FC40 40pin Flat Rainbow Ribbon Cable
10 x 1kΩ Resistor
1 x Screwdriver
1 x T-Extension
9 x LED (3 red, 3 yellow, and 3 green)
12 x Screws(4 x M3*6 screws ,4 x PWM2*6 screw, 4 x PWM2*4 screws)
The Sunfounder breadboard kit fits perfectly for a Raspberry Pi 3B+, 3 Model B, 2 Model B and 1 Model B+ , an Arduino Uno or Mega 2560
The high quality RAB Holder makes everything convenient and neat.Enlarge the fun when you fix the Raspberry Pi and Arduino boards.
This 830-tie/point breadboard includes an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails.
Including T-shape GPIO Extension Board and Ribbon Cable, which are special for Raspberry Pi 3 Model B+, 3 Model B, 2 Model B, 1 Model B+
Comes with male-to-male 65pcs jumper wires, red, green, and yellow LEDs, ten 1kΩ resistors, a screwdriver, and some screws.

If you have any confusions about this product, you can make a comment below, we try to solve the user questions as soon as possible.

Leave a Reply